--------------5D8BC909278FC2F51939222D
Content-Type: text/plain; charset=us-ascii
Content-Transfer-Encoding: 7bit
Hi Bret, Here is the final taper I promised. A very rare a neat 6'
Heddon. Rod has the Typical plastic reelseat but the grip has a factory
installed elevated thumb rest as found on Marvin Hedges Heddon rods. Rod
is more of a miniuture trout rod then a midge rod.Marty PS. neat
ovens!
6' 2/2 DT#4 #14 Heddon
measured over varnish deduct .004"
Butt Tip
00 .178 .075
05 .184 .085
10 .200 .097
15 .218 .112
20 .233 .128
25 .245 .138
27 .252 (start of grip)
30 .252 .157
35 .252 .165
Guide spacing: 4 3/8", 10", 16 7/8", 24 5/8", 32 1/8", 40 1/8",
48 7/8"
wrote:
> I do not remember if I told you thanks for the taper. Thanks
> Bret
--------------5D8BC909278FC2F51939222D
Content-Type: text/html; charset=us-ascii
Content-Transfer-Encoding: 7bit
Hi Bret, Here is the final taper I promised. A very rare a neat 6' Heddon.
Rod has the Typical plastic reelseat but the grip has a factory installed
elevated thumb rest as found on Marvin Hedges Heddon rods. Rod is more
of a miniuture trout rod then a midge rod.Marty PS. neat
ovens!
6' 2/2 DT#4 #14 Heddon
measured over varnish deduct .004"
Butt
Tip
00
.178
.075
05
.184
.085
10
.200
.097
15
.218
.112
20
.233
.128
25
.245
.138
27
.252 (start of grip)
30
.252
.157
35
.252
.165
Guide spacing: 4 3/8", 10",
16 7/8", 24 5/8", 32 1/8", 40 1/8", 48 7/8"
wrote:
I do not
remember if I told you thanks for the taper. Thanks
Bret
--------------5D8BC909278FC2F51939222D--